Winkelmandje

X kiinni
kiinni

SMART terät UN TRA 100x100mm eristysveitsi 1.

10,0/10 (1 arvostelut)

SMART terät UN TRA 100x100mm eristysveitsi 1.

Loppu varastosta

Kirjoita sähköpostiosoitteesi ja saat viestin heti, kun tuotetta on taas varastossa.

  • Kuvaus

Uusi innovaatio SMART Tool Groupilta. Räätälöity eristyslevyjen leikkaamiseen. Voidaan käyttää myös vaahtomuoviin ja muihin pehmeisiin materiaaleihin. Tekniset tiedot:
Tuotenumero: HINB1
Viivakoodi: 0614019503171
Brändi: SMART
Nettopaino (kg): 0,05
Sovellus: Sahaus
Liitäntä: Universal
Sahanterän pituus: 100 mm
Sahanterän rakenne: Muu
Leikkaussyvyys: 100 mm
Muoto: Muu
Sopii ei-rautametallille: Ei
Sopii muoville: Ei
Sopii ruostumattomalle teräkselle : Ei< br>Sopii teräkselle: Ei
Sopii kivelle: Ei
Sopii puulle: Ei
Logo 2:

Artikkelinumero: 11260-E

  • "Bought this as I had to hack into loads of celotex to run wires, after the chuck"

    tuntematon -

    Bought this as I had to hack into loads of celotex to run wires, after the chuckle brothers (aka the builders from hell) decided to insulate before I could run my wires.
    Using a dewalt 18v multitoool, cut into foam board on low speed. It slices so isn’t much mess (rather than using a rusty old saw) to get into the back of your throat. I used it to cut shallow channels (Popping out the centre of the cuts either side) and also for cutting 40mm board before plasterboarding over the top. I’m not sure if the blade is long enough for cutting100mm celotex. The box also shows that it can be used in fibreglass insulation but I’ve not tried that yet either. 

Kirjoita arvostelu

Autat muita heidän valinnassaan jakamalla kokemuksesi.

Vastaa kysymykseen: Mikä on ?

Nopea toimitus ympäri Eurooppaa!
Harkinta-aika 14 päivää
Asiakaspalaute 9,5/10
Toimitusajat 1-3 arkipäivää
Viimeksi katsellut tuotteet
Harkinta-aika 14 päivää
Toimitusajat 1-3 arkipäivää